View Video

• Create the Gerber files from Fabrication Manager. (Fabrication  | Setup | Gerber Artworks | Set to used | Execute | Execute  | Close | Close )
• Invoke Fabrication Manager | File | Fabrication Graphics Viewer.
• A window as below pops up. Filter the Files of Type as Gerber ASCII Files (*.GBR)

Note:
xx_00.GBR -> Component Print (or Silkscreen Top)
xx_02.GBR -> Component Layer or Artwork Top Layer (This layer is not required for a single layer PCB).
xx_29.GBR -> Solder Layer or Artwork Bottom Layer

• Select the required Gerber file, here xx_00.GBR is selected and choose the Import to Layer as Silkscreen Top

• Next select xx_29.GBR and choose Import to Layer as Artwork Bottom Layer. Then add Image X Offset = 2.5000”

• From below figure, it can be seen that, the gerber files created is offsetted.

• Select File | Print from Fabrication Graphics Viewer to print the layers.

• Choose Centre image in 1x1 pages from the Print Preview and then print the page.