Trace frames showing wrong trace width

[Bengt]

Trace frames show traces of 0.2 mm as if they were 0.15 mm! True size shows correct width.

[EDWin Support]

Dear Bengt,

We have checked this and could not reproduce. Please clarify whether this problem is specific to a single project or for the entire EDWinXP installed in your system and the steps to reproduce it.

[Bengt]

No special way to reproduce it. This is how it lookes like: 0.2 mm wire, grid 0.1 mm.

Wire.png

[Bengt]

Please verify again that you can't reproduce this problem.

[EDWin Support]

Dear Bengt,

As per the information obtained from the R & D, it is as designed. The Centerline format doesn't show true size either. But when u do clearance check and measure distance, the proper width is applied.

[Bengt]

Do you think it is possible to make the trace outline show the same size as true size? I think it is really bad that they are not.