Change component text
Moderator: EDWin Support
3 posts
• Page 1 of 1
Change component text
by TLEC » Fri Feb 24, 2012 5:57 pm
Is it possible to change all component text, i.e size etc in one single operation.
- TLEC
- Rank#7
- Posts: 227
- Joined: Fri May 09, 2008 2:27 am
- Location: Borås, Sweden
Re: Change component text
by Bengt » Sun Feb 26, 2012 6:01 pm
Yes it is (almost). "Select All" (CTRL-A), right click anywhere, change text size of for example all nets.
-
Bengt - Rank#7
- Posts: 197
- Joined: Thu Mar 06, 2008 6:02 pm
- Location: Linköping
Re: Change component text
by Ken » Mon Feb 27, 2012 12:10 pm
DearTELC,
Select All->right click ->select properties-> then Layout component(in Layout editor)/Schematic component text(in Schematic editor) and change text properties.
Select All->right click ->select properties-> then Layout component(in Layout editor)/Schematic component text(in Schematic editor) and change text properties.
Best Regards,
Ken
Ken
- Ken
- Rank#1
- Posts: 15
- Joined: Thu Mar 05, 2009 12:37 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest